Ordered conducting polymer multilayer films and its application for hole injection layers in organic light-emitting devices

We reported a controlled architecture growth of layer-ordered multilayer film of poly(3,4-ethylene dioxythiophene) (PEDOT) via a modified Langmuir-Blodgett (LB) method. An in situ polymerization of 3,4-ethylene dioxythiophene (EDOT) monomer in multilayer LB film occurred for the formation of ordered conducting polymer embedded multilayer film. The well-distribution of conducting polymer particles was characterized by secondary-ion mass spectrometry (SIMS). The conducting film consisting of ordered PEDOT ultrathin layers was investigated as a hole injection layer for organic light-emitting diodes (OLEDs). The results showed that, compared to conventional spin-coating PEDOT film and electrostatic self-assembly (ESA) film, the improved performance of OLEDs was obtained after using ordered PEDOT LB film as hole injection layer. It also indicated that well-ordered structure of hole injection layer was attributed to the improvement of OLED performance, leading to the increase of charged carrier mobility in hole injection layer and the recombination rate of electrons and holes in the electroluminescent layer.     

X射线Kirkpatrick-Baez显微镜用超反射镜的研制

 介绍了一种可应用于X射线Kirkpatrick-Baez（KB）显微镜的光学元件—X射线超反射镜。选用的W和B₄C作为镀膜材料，膜对数为20，采用单纯型调优的方法实现了X射线超反射镜设计，用磁控溅射的方法在Si基片上完成了W/B₄C X射线超反射镜的制备。采用高分辨率X射线衍射仪（8 keV）测量了X射线超反射镜的反射特性。制备的X射线超反射镜在掠入射角分别为1.052°和1.143°处，反射角度带宽为0.3°，反射率达到20%，可满足KB型显微镜的要求。     

激光等离子体脉冲软X光标定源

 利用神光Ⅱ上激光与等离子体相互作用得到的软X光，建立了基于多层镜的四通道软X光单色器系统。研究了光源的性能，测量了光源强度、单色器系统稳定性、相应通道的一致性。研究表明，采用多层镜作为脉冲光源的分光元件，可以得到具有较好单色性的强脉冲软X 光标定源。光源的光子能量为253 eV和820 eV，两能道的光源强度分别为1.8×10¹⁹ photon/(s·cm²)和3.2×10¹⁹ photon/(s·cm²)。在该标定源上可以实现XRD、平面镜、多层镜、透射光栅和滤片的标定。     

Multilayer adsorption of alcohols from benzene/n-heptane mixtures on silica gel

An equation for multilayer adsorption from multicomponent liquid mixtures on solid surfaces¹ has been examined. For this purpose experimental adsorption data for four alcohols from benzene/n-heptane mixture on silica gel have been measured. Average number of the adsorbed layers, heterogeneity parameter and capacity of the surface phase have been evaluated by using the equation mentioned above.

---

Mehrschichten-Adsorption von Alkoholen aus Benzol/n-Heptan-Mischung an Silica Gel

Zusammenfassung Eine Gleichung für Mehrschichten-Adsorption an festen Oberflächen¹ aus Mehrkomponentenlösungen wurde getestet. Zu diesem Zweck wurden experimentelle Daten für die Adsorption von vier Alkoholen aus Benzol/n-Heptan-Mischung an Silica Gel herangezogen. Der Mittelwert für die Anzahl der Adsorptionsschichten, der Heterogenitätsparameter und die Kapazität der Oberflächenphase wurde aus dieser Gleichung berechnet.

     

Simultaneous acquisition of X-ray spectra using a multi-wire, position-sensitive gas flow detector

A multi-wire, gas-filled position-sensitive detector has been developed for the simultaneous recording of wavelength-dispersed X-ray signals that enables X-ray fluorescence spectrometry with a limited multi-element capability in the low Z element range. Details of the modular construction of the detector are given. The detector performance was characterized using Al–K radiation and a variable slit system. The detector has been applied in a laboratory spectrometer equipped with an electron source and a double multilayer mirror device as the wavelength-dispersing element. Spectra from Al and Si obtained in the simultaneous acquisition mode show good agreement with calculations performed using a ray-tracing model.     

Influence of polyelectrolyte coating conditions on capillary coating stability and separation efficiency in capillary electrophoresis

Polyelectrolytes are widely used in capillary electrophoresis as coating agents of silica capillaries to prevent adsorption phenomena and improve the repeatability of peptide and protein analysis. A systematic study of the coating experimental conditions has been carried out to optimize coating stability and performance. The main experimental parameters studied were the type and concentration of polyelectrolytes used in several monolayer and multilayer coatings, the ionic strength of coating and stabilizing solutions, and the procedures used for coating and capillary storage. Electroosmotic flow magnitude, direction and repeatability were used to monitor coating stability. Coating ability to limit adsorption was investigated by monitoring variations of migration times, time-corrected peak areas and separation efficiency of test peptides. Capillary-to-capillary and batch-to-batch reproducibility was also studied. In addition, the separation performance of polyelectrolyte coatings were compared to those obtained with bare silica capillaries.     

X7R型MLCC流延瓷膜显微结构的AFM研究

片式电容是由电介质陶瓷薄膜和内电极相互重叠而成的多层独石结构,又称多层陶瓷电容器(mul-tilayer ceram ic capacitors,简称MLCC)。具有体积小、内部电感低、绝缘电阻高及漏电流小、介质损耗低、价廉等优点,被广泛应用于各种电子整机中的振荡、耦合、滤波和旁路电路,尤其是高     

New generalized computations of quasi-planar waveguides characteristics

An efficient hybrid field solution to the general multilayer substrates transmission line problems with full shielded and half open cross-sectional geometry is presented by using the waveguide modes coupling and decoupling procedure in the spectral domain. Modal transverse transmission lines corresponding to the LSE and LSM modes are taken into account so that the Green's elements for the edge conditions can be derived by a simple iterative method. In this paper, we analyze not only the propagation constants and characteristic impedances but also the available transmission power capacity and power distribution of most commonly used structures. Normalized eigenmode power levels characterizing the propagation features are computed.     

Multilayer films of cationic surfactants incorporating polyoxometalate on electrodes

A new kind of multilayer of didodecyldimethylammonium bromide (DDAB) and 1:12 phosphomolybdic anions (PMo₁₂) was achieved on the surface of a wax-impregnated graphite (WIG) electrode by ion exchange and electrostatic interaction. The characterization and electrochemical behavior of the multilayer films of DDAB/PMo₁₂ is described in detail. The chemically modified electrode was shown to exhibit an excellent electrocatalytic activity toward the reduction of BrO₃ ^– anion in 0.5 M H₂SO₄ and possesses several attractive features, such as simple preparation, fast response, good stability, etc. Electronic Publication     

Comparative study on the interaction of DNA with three different kinds of surfactants and the formation of multilayer films

The interactions between double-stranded DNA (dsDNA) and three different kinds of surfactants, i.e., cationic, anionic, and nonionic surfactants, were investigated by cyclic voltammetry, electrochemical impedance spectroscopy and UV-vis spectroscopy. Multilayer films composed of DNA and surfactants were prepared at gold electrode by electrostatic or hydrophobic interactions. It was found that the cationic surfactant, CTAB, can bind to DNA by electrostatic interaction, and the electron transfer resistance of CTAB-DNA complex film increases first and then decreases with CTAB concentration. The anionic surfactant, LAS, can bind to DNA but by hydrophobic interaction, and the electron transfer resistance of the complex film keeps decreasing with LAS concentration. Nonionic surfactants can also directly bind to DNA by hydrophobic interaction. All the three different kinds of surfactants can form multilayer films with DNA on the electrode surface. The chemical structure of DNA keeps unchanged during interacting with these surfactants. The binding modes of DNA with these three different kinds of surfactants were also deduced.